In int4 IFTT In Int4 IFTT, test case creation is based on re-using reusing automation objects (aka also called configuration objectobjects). The This kind of object must be created for each tested interface before the first test case. Then it is reused for all other test cases for the same interface.
The configuration manual is split into two sectionsections. First The first one describes all possible configuration parameters and available options. Second The second section is focused on particular test types and explains the settings per particular specific scenario.
- Automation Object contains all of the available settings and parameters without a split into particular scenarios
- Configuration Guides contains step by step walk-throughs of how to set:
- configuration object for the inbound interface
- configuration object for the outbound interface
- configuration object for the synchronous interface
- eCATT configuration object
- Creating the configuration object for IDOC Inbound Interface
- Creating the configuration object for IDOC Outbound Interface
- Creating the configuration object for AIF Inbound Interface
IFTT configuration can be performed through You can use transaction /INT4/IFTT_CONF to perform IFTT configuration.