Page Comparison

USE: 

In order to test synchronous interfaces with int4 IFTT a new receiver Communication Channel should be created on PI. This channel should be a copy 
of the sender communication channel used by the tested interface. The Target URL of the newly created receiver communication channel should be the sender channel endpoint.  

PROCEDURE: 

1. On PI find the Integrated Configuration (ICO) that is used in the tested scenario. 
2. Locate the sender Communication Channel in ICO → Inbound Processing and enter its configuration
   
   
   
3. Copy the entire object
   
   Image Added
   
   
4. Change its name to 'receiver' and add a suffix to distinguish it from other communication channels used in the scenario. 
   
   Image Added
   
   
5. Below you will find a sample receiver Communication Channel configuration for HTTP and SOAP adapter: 
   
   

A) HTTP:

Sender channel endpoint (Target URL):

[PI url]:port/HttpAdapter/HttpMessageServlet?interfaceNamespace=[interface namespace]&interface=[interface name]&senderService=[channel communication component]&qos=BE

Please take notice that for HTTP you should use SOAP adapter, but with "Do not use SOAP envelope" conversion parameter ON. 

Image Added

In the module tab add XISOAPAdapterBean module. 
Image Added

B) SOAP: 

Sender channel endpoint (Target URL):

[PI url]:port/XISOAPAdapter/MessageServlet?senderParty=&senderService=[channel communication component]&receiverParty=&receiverService=&interface=[interface name]&interfaceNamespace=[interface namespace]

Image Added

In the module tab add XISOAPAdapterBean module. 
Image Added

To complete the synchronous interface configuration in int4 IFTT add the following data as additional parameters in the Object Definition of your synchronous scenario:

• business component of a receiver channel for sender
• receiver communication channel for sender
• party of a receiver channel for sender (if blank in the ICO on PI, leave it blank in int4 IFTT configuration)
  

Image Added