Page Comparison

Parameter name

Description

Example

Inject using PIT

HTTP RFC Destination

Alternative RFC Connection where the REST message should be sent. If this parameter is populated, then the message will be sent there alternative RFC.

SAPSYS1_RFC

Direct HTTP URL

Direct endpoint to tested interface (synchronous).
It should be provided without PI endpoint & port. 

Additionally, if the URL is dynamic (like JSON queries), it is possible to enter the variable name in {} brackets. The value will be substituted before calling the final URL

/RESTAdapter/webshop/salesOrder/
create/1/{PONUMBER}/1

Direct HTTP operation

If the direct endpoint is provided, here you can specify the HTTP operation (for synchronous REST testing)

PUT, GET, POST

PI: Reference Sender Channel Name

Name of the sender channel to be used as a reference. 

CC_SOAP_SENDER

PI: Reference Sender Channel BC

Business Component of the sender channel to be used as a reference. 

BC_SENDER

PI: Reference Sender Channel Party

Party of the sender channel to be used as a reference. 

SENDER_PARTY

Flag for Flat File interfaces

Used to mark interface input as Flat File

Flat File Line Separator

The character used for end-of-line determination in Flat File messages: for example, CLRF - Unix. The parameter is used to display the comparison report better and display the reference and new message line by line.

"Carriage Return and New line" character should be stored as CRLF

"Line Feed" should be stored as LF (Unix based files)

There is no default value, so the parameter is obligatory for CSV files

CLRF

Line Separator Escape Character

Escape character for line separator. Used to avoid line breaks in case separator is used in the file content.
Value of this parameter should be aligned with specific format used by tested interface.
Example: If line separator is set to ' and escape character is ? following split is applied:

Source:
NAD+SU+8720121000874::3++Test?'file'NAD+SU+8236459000874

Split:
NAD+SU+8720121000874::3++Test?'file'
NAD+SU+8236459000874

Flat Files Compare with payload validations applied

If this checkbox is checked, Payload Validation rules are applied before files comparison and the match content is replaced by the placeholders. This can in some cases result in better flat file comparison results, especially in case of many missing lines.

Do not fail TC if DB reference not found

This flag determines if in the situation when DB validation for reference messages have not been found whether it should be treated as Error or Successful message.

Checked or 'X' - if reference document is not found test case will not be failed

Unchecked or '' - if reference document is not found test case will be failed (default setting)